North Shore Winter Plumbing Checklist: How to Prevent Frozen Pipes Before the Freeze

What to do in October so you’re not calling a plumber in January

The first hard freeze on the North Shore usually lands in late October or early November, and every year it finds the same weak spots: a hose left on the spigot, a pipe in an exterior wall, a crawlspace nobody’s looked in since spring. A burst pipe can put hundreds of gallons of water into a finished basement before anyone notices. An afternoon of prep in the fall prevents almost all of it.

Here’s the checklist we run through, in the order it makes sense to do it.

At what temperature do pipes freeze?

The rule of thumb is 20 degrees. Pipes inside a heated house are generally safe until the outside temperature drops to about 20°F, and the risk climbs fast below that. Pipes in unheated spaces, like a crawlspace, garage, attic, or an exterior wall with a draft blowing on them, can freeze at 32°F if it stays cold long enough. Wind chill matters too, because wind pulls heat out of a wall faster than still air does.

Water damage and freezing are consistently among the most common and most expensive homeowners insurance claims, and a single burst pipe can run well into five figures once you count flooring, drywall, and what was in the basement.

The checklist

1. Disconnect hoses and shut off outdoor spigots

This is the one that causes the most damage, and it’s the easiest to fix. A hose left on the spigot traps water in the spigot body. That water freezes, expands, and splits the pipe just inside the wall, where it’s warm enough that you won’t see a problem until you open the spigot in April and water pours into the basement.

  1. Find the indoor shutoff for each outdoor spigot. It’s usually on the basement ceiling near the exterior wall, and it looks like a small valve on the pipe heading toward the outside. Turn it off.
  2. Go outside, take the hose off, and open the spigot all the way to let the water drain out. Leave it open.
  3. Back inside, find the small bleeder cap on the side of the shutoff valve. Hold a cup under it, unscrew it, let the last bit of water out, and put the cap back.

If you have frost-free spigots (the handle is on a long stem that reaches back into the warm part of the wall), you still have to take the hose off. A frost-free spigot only protects itself if it can drain, and a hose stops it from draining.

2. Insulate pipes in unheated spaces

Crawlspaces, garages, attics, and unfinished basement corners along the foundation are where pipes freeze. Foam pipe sleeves from the hardware store go on in minutes and cover most of the risk. Both hot and cold lines need it.

Insulation slows heat loss but doesn’t make heat. For a pipe that’s frozen before, or a long run through a really cold space, self-regulating heat cable is the fix. It plugs in, runs along the pipe under the insulation, and only draws power when the pipe gets cold.

3. Seal the drafts

A pipe freezes where cold air hits it. Walk the basement and crawlspace with your hand out on a cold day and feel for drafts along the rim joist (the wood band where the house sits on the foundation), around foundation vents, and where pipes and wires come through the wall. Seal gaps with caulk or expanding foam. Close crawlspace vents for the winter if they’re the manual kind.

4. Check your sump pump discharge line

This one gets overlooked. The pipe that carries water from your sump pump outside can freeze at the outlet, especially if it ends in a low spot or runs a long way above ground. When it freezes, the pump keeps running against a blocked line, burns itself out, and the pit floods. Make sure the discharge line drains completely after the pump stops, slopes downhill the whole way, and isn’t buried in snow or leaves at the end.

5. Blow out the irrigation system

If you have lawn sprinklers, the lines need to be blown out with compressed air before the ground freezes. Water left in them cracks the pipes and the backflow preventer, and that’s a spring repair bill. Shut off the sprinkler supply valve inside the house too.

6. Find and test your main water shutoff

Everyone in the house should know where it is and how to turn it off. It’s usually in the basement on the wall facing the street, near the water meter. Turn it off and on once now to make sure it moves. If it’s an old round-handle gate valve that’s stiff or won’t close all the way, have it replaced with a quarter-turn ball valve before winter. The worst time to find out your main shutoff is seized is with water spraying out of a wall.

7. Set up the house for cold snaps and travel

  • Keep the thermostat at 55°F or higher, even when you’re away for a week.
  • On the coldest nights, open the cabinet doors under sinks on exterior walls so room air reaches the pipes.
  • Let a cold faucet on an exterior wall drip. Moving water is much harder to freeze, and it relieves pressure if ice does form.
  • Keep the garage door closed if any water lines run through the garage.
  • Going away for a long stretch? Shut off the main, open the faucets to drain the lines, and have someone check the house. A smart leak sensor or an automatic shutoff valve on the main line is worth the cost if you travel in winter.

8. Look at the water heater

Winter is the hardest season on a water heater because incoming water is colder. If yours is over 10 years old or making noise, get it looked at now rather than in a January cold snap when every plumber is busy. If you have a tankless unit, make sure its condensate drain line isn’t routed somewhere it can freeze.

What should you do if a pipe freezes anyway?

The first sign is a faucet that gives you a trickle or nothing at all on a cold morning. If you see frost on an exposed pipe, that’s the spot.

  1. Find the main shutoff and be ready to close it. If the pipe has already split, ice may be the only thing holding the water back.
  2. Open the faucet the frozen pipe feeds. That gives water somewhere to go as the ice melts.
  3. Warm the pipe slowly with a hair dryer, a heating pad, or towels soaked in hot water, starting at the faucet end and working back toward the frozen section.
  4. Never use a torch, an open flame, or anything with a flame. It’s a fire risk, and it will melt PEX or ruin a solder joint.
  5. If you can’t reach the frozen section, or water starts coming out of the pipe or the wall, shut off the main and call us.

If a pipe does burst: shut off the main, open the faucets to drain the pressure, turn off power to the area if water is near outlets or the panel, and move what you can. Then call.

Frequently asked questions

At what temperature will pipes freeze?

Around 20°F for pipes inside a heated home. Pipes in unheated spaces or exterior walls can freeze at 32°F in a prolonged cold snap, especially with wind.

Do frost-free spigots still need to be winterized?

Yes. Take the hose off so the spigot can drain. If there’s an indoor shutoff for the line, close it and drain it too. A frost-free spigot with a hose attached will freeze and split just like a regular one.

Should I leave faucets dripping during extreme cold?

Yes, on the coldest nights, a cold-water faucet on an exterior wall. A steady drip is enough. It costs a few cents in water and can save a burst pipe.

How do I find my main water shutoff valve?

Usually in the basement or crawlspace on the wall facing the street, where the water line comes in, near the water meter. In some homes it’s in a utility room or near the water heater. Find it before you need it.

What temperature should I keep the house at when traveling in winter?

55°F at a minimum. Below that, pipes in exterior walls are at risk even with the heat on. For a long trip, shut off the main and drain the lines as well.

Why did my pipe burst when it thawed and not when it froze?

Ice expanding inside the pipe causes the split, but the ice itself plugs the hole. When it thaws, the water comes through. That’s why you should have the main shutoff located before you start thawing anything.

Winterization help on the North Shore

Biagi Plumbing has been helping North Shore homeowners get ready for winter since 1989, in Evanston, Wilmette, Winnetka, Glencoe, Highland Park, Lake Forest, Lake Bluff, Deerfield, Northbrook, Glenview, Libertyville, Buffalo Grove, and the surrounding communities.

If you’d rather have someone else go through this list, call Biagi Plumbing at (847) 512-8921. We’ll shut off and drain the outdoor lines, check the pipes in the crawlspace and other cold spots, test the main shutoff, look at the sump discharge, and fix anything that’s going to be a problem in January. And if a pipe does freeze this winter, call us before it thaws.

Contact Us

By checking this box and signing up for texts, you agree to receive informational messages (appointment reminders, account notifications, marketing and promotional messages such as sales, coupons, seasonal deals, etc.) from Biagi Plumbing Corporation at the number provided. Msg & data rates may apply. Msg frequency varies. Unsubscribe anytime by replying STOP. Reply HELP for help or email us at [email protected]. Learn more on our Privacy Policy & Terms & Conditions

Schedule Now

By checking this box and signing up for texts, you agree to receive informational messages (appointment reminders, account notifications, marketing and promotional messages such as sales, coupons, seasonal deals, etc.) from Biagi Plumbing Corporation at the number provided. Msg & data rates may apply. Msg frequency varies. Unsubscribe anytime by replying STOP. Reply HELP for help or email us at [email protected]. Learn more on our Privacy Policy & Terms & Conditions

Americans with Disabilities Act (ADA) Notice

At Biagi Plumbing, we are committed to ensuring that individuals with disabilities enjoy full access to our websites. In recognition of this commitment, we are in the process of making modifications to increase the accessibility and usability of this website, using the relevant portions of the Web Content Accessibility Guidelines 2.0 (WCAG 2.0) as our standard. Please be aware that our efforts are ongoing. If at any time you have difficulty using this website or with a particular web page or function on this site, please contact us by phone at (847) 512-8921; or email us at ([email protected]) and place “Web Content Accessibility (ADA)” in the subject heading and we will make all reasonable efforts to assist you.